Left Continue shopping
Your Order

You have no items in your cart

Sealer & Coating Remover - AquaMix

$164.00
GST included

This safer, non-flammable, multipurpose stripper effectively removes most sealers, epoxy grout haze, urethane coatings, synthetic finishes, adhesives, paints, as well as deep-set oil stains and heavy grease build up. Its unique formula allows it to stay wet for a longer period of time, maximizing its removal capabilities.

AquaMix Sealer & Coating Remover Key Features:

  • Removes sealers, coatings and finishes
  • Non acidic 
  • Formulated with a long dwell time, it is highly effective for challenging projects.
  • Cleans deep-set stains, epoxy grout haze, adhesives and paint

Sealer & Coating Remover Uses:

This product is effective for removing sealer and coating from various surfaces, including natural stone (such as granite, limestone, marble, slate, and travertine), ceramic, porcelain, grout, quarry, Saltillo, terra-cotta, cement pavers, and masonry.

Sealer & Coating Remover Limitations

  • Do not allow the product to come in contact with any non-recommended surface
  • Do not spray
  • Do not use on resinous synthetic agglomerates

How to use AquaMix Sealer and Coating Remover

It is recommended to wear chemical-resistant gloves, specifically nitrile, while handling this product. Additionally, ensure the work area has proper air ventilation.

STRIPPING

  1. When using this product, make sure to carefully read the entire label and provide adequate air ventilation in the room or area of application. Prior to application, it is important to sweep or vacuum the surface. 
  2. Apply a generous amount of Sealer & Coating Remover to a manageable area of up to 25 ft (2 M) and spread it with a mop or brush.
  3. Let the product sit for up to 1 hour without drying, or until the coating or residue becomes soft. It is crucial to prevent the remover from drying on the surface, so be sure to add more if needed.
  4. Use a scrub brush or machine to agitate the area and wipe up the residue with clean, absorbent white cotton towels. A wet/dry vacuum can also be used.
  5. For thicker coatings or residue, multiple applications may be necessary - simply repeat steps 3 through 7 until the surface is clean.
  6. Rinse thoroughly with water and allow for at least 1 hour for surface traffic or until

EPOXY GROUT HAZE REMOVAL

  1. Carefully read the entire label before applying. Use a small, manageable area of up to 25 ft (2 M) and evenly spread the Sealer & Coating Remover using a mop or brush.
  2. Let the product sit for up to 1 hour without drying and lightly scrub the surface with a scrub brush to remove any haze. For larger commercial areas, a white pad and scrub machine may be used.
  3. Clean up any dirty residue and thoroughly rinse with clean water. The surface will be ready for traffic in approximately 1 hour, depending on ambient temperature conditions.
  4. Allow at least 24 hours for the surface to fully dry before applying Aqua Mix® sealers and floor finishes.

Customer Reviews

Be the first to write a review
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)